Search results for "Electroless deposition"

Developing a procedure to optimize electroless deposition of thin palladium layer on anodic alumina membranes

2006

In recent years, the increased demand for hydrogen in many industrial applications, like petrochemical and semiconductor processing, and sustainable energy (fuel cells) has led to a renewed interest in methods for separation and purification of hydrogen from gas mixtures. In particular, palladium-based membranes have been the subject of many studies, due to their potential use as hydrogen-selective membranes for gas separation or purification [1,2]. Owing to the high cost of palladium and in order to increase the flow rate of hydrogen, composite membranes, formed by a thin layer of palladium deposited on a porous support, are largely preferred to thick self-standing metal membranes. Differe…

Anodic alumina membranes: from electrochemical growth to use as template for nanostructure fabrication

2009

Mechanically stable metal layers for ohmic and blocking contacts on CdZnTe detectors by electroless deposition

2015

CdZnTe detectors are commonly exploited for the detection of gamma rays. However, obtaining mechanical stable, low noise contacts on CdZnTe is still an issue. In particular, ohmic contacts would be preferable for high flux applications. In this work, we show that it is possible to obtain mechanical stable gold contacts by electroless deposition in methanol solution. Moreover, we show that electroless deposited nickel contacts are also mechanical stable and are good candidates for the realization of ohmic contacts on high resistivity CdZnTe crystals.

Optimized bath for electroless deposition of palladium on amorphous alumina membranes

2006

A new bath for the electroless deposition of palladium on anodic alumina (AA) membranes is proposed. It was found that the optimal conditions for the uniform deposition of palladium, with minimal damage to the AA membranes, were under conditions of pH 8.4 and plating times shorter than 30 min. The deposited Pd layer was detected by X-ray diffraction (XRD) and energy dispersive X-ray (EDX) analysis. The morphology of the AA membrane before and after plating was examined by scanning electron microscopy (SEM). EDX analysis revealed that palladium was deposited only on the surfaces of the membrane and Sn ions, coming from the sensitizing bath, were incorporated into the palladium layer. EDTA in…